Fitting A Door Handle And Latch

Installing a door handle is a relatively easy home project that you can do with a pre made kit.
Fitting a door handle and latch. Also chisel inside the hole for the latch to fit. A helpful guide for fitting a tubular latch in your interior door. Establish the handle height and mark the door. Use masking tape to secure the door handle kit s template to the door at this spot.
Step by step guide to fitting a mortice latch door handles. The cuts made with the utility knife are your guidelines as to where to stop chiselling. The latch plate can now be fitted to the door frame. Marking the door handle positions.
Follow our handy guide to fitting interior door handles. Before you can fit a door handle to a new door you will first need to mark regions to be drilled and cut. Use the sharp chisel and the hammer to chisel out a hole for the latch. Once the door is open try to actuate the door latch with the handle.
Fitting door handles may appear complicated at first but it is an easier task then you think. Make sure that. Close the door to and mark the centre of the latch tongue on the door frame. Simulating opening the door without the latch extending into and retracting out of the strike plate.
Put your tape measure on the floor in front of your door and measure up 41 inches from the floor since this is the most common placement for door handles. The handle or knob must be jiggled to unstick the latch. Door latch screwed up firmly on to door. The normal height for fitting a mortice latch is a metre up from the floor around 3 feet but you can either match existing handle heights ask the client how high they want them or check the drawing schedule to find out which height to drill the handles.
With the latch securely fitted to the door it s now time to get the handles fitted. More force is needed to turn the knob and unstick the latch. The door latch is not extended before rotating the knob. Insert the latch into the side of the door to see if its faceplate sits flush to the door.
Pick one side of the door to start on either side is fine. Mark your brand new door with the location.